Konka rear projection TV BT4301 bus entry method - android - Phones Developers

Heng Jiaxing AO3401

Brand AVX TPSE226M035R0125 Low impedance tantalum capacitor AVX 22

Electronic scale crystal oscillator 3.2*2.5mm 3225 16M (16.000MHZ) 12PF 10PPM 20PPM 30PPM

Probe domestic PA100-H2 diameter 1.36 thimble total length 33.35MM current

0603 Blu-ray factory direct sales

Konka rear-projection TV BT4301 rear-projection color TV, there are two kinds of adjustment remote control: one is the remote control used by the factory; the other is the remote control used by the user. The two remote controls function exactly the same, except that the remote control used in the factory has a “convergence” button for the remote control used by the user. In fact, the user's remote control's "picture still" button also has a "convergence" button, just to prevent the user from misuse, seal it in the outer casing of the remote control. If you need to adjust the convergence, you only need to add a conductive button to enter the factory adjustment menu. When adjusting the convergence, the TV must be preheated (powered on) for more than 30 minutes. The method of entering and exiting the maintenance state is as follows.

Press the “Convergence” button on the remote control, and the green square line will be displayed on the screen. Press the “call sign” button on the remote control to enter the user convergence adjustment state. The screen displays red and green square lines on the screen. A small red rectangle cursor is displayed in the middle.

After the convergence adjustment (the red and blue squares coincide with the green square image), press the “Audio” button on the remote control to store the adjusted data. Wait for 3 s and then press the “Convergence” button to exit the convergence adjustment state. .