555 integrated projection automatic protection power failure circuit

The 555 circuit, which contains two voltage comparators, a basic RS flip-flop, and a discharge switch T, the comparator's reference voltage is provided by a voltage divider consisting of three 5K resistors. They respectively make the non-inverting input of the high-level comparator A1 and the inverting of the low-level comparator A2, and the reference levels of the input terminals are 2/3VCC and 1/3VCC. The outputs of the A2 and A2 control the RS flip-flop state and Discharge tube switch status. When the input signal is from the 6 pin, that is, the high level triggers the input and exceeds the reference level 2/3VCC, the flip-flop resets, the output of the 555 pin 3 outputs a low level, and the discharge switch tube is turned on; when the input signal is from 2 The input of the pin is lower than 1/3VCC, the trigger is reset, the 3 pin of 555 outputs high level, and the discharge switch tube is cut off. RD is the reset terminal (4 pins). When RD=0, 555 outputs a low level. Usually the RD end is open or connected to VCC.

555 integrated projection automatic protection power failure circuit
Film screening automatic protection power outage circuit diagram


Ferrite Driver Unit

Why do you like to use ferrite magnets? Because it does not rust, does not oxidize, does not corrode and is absolutely environmentally friendly.
Why don't ferrite magnets rust?
The chemical name of ferrite magnet is iron tetroxide. The main components are: Fe3O4. It is already an oxide of iron, so it is very difficult to be oxidized again. Other magnets (the main component is iron) are made of magnetized metal iron or other elements. Like other iron and steel, they can be oxidized and rusted, and the oxidized part will lose their magnetism.
What are the advantages (advantages) of ferrite magnets
1. Low cost, low price. Raw material cost is cheap.
2. Good temperature stability. It can be used in temperatures of -40 degrees Celsius and +350 degrees Celsius.
3. It is just mentioned that it does not rust.
4. The demagnetization curve is approximately a straight line.
5. Light weight, density is (4.6-5.1) X103kg/M3
6. The anisotropy constant of the magnetic crystal is large.
7. Large coercivity Hc (between AlNiCo alloy material and rare earth cobalt permanent magnet material)
8. High resistivity.ferrite magnet driver unit

Ferrite Driver Units,Speaker Driver Unit,driver unit with ferrite magnet,Ferrite Drivers,Horn Speaker Driver

Taixing Minsheng Electronic Co.,Ltd. , https://www.ms-speakers.com

This entry was posted in on