1.Unplug the device and take it apart using an appropriate screwdriver. This could mean using a Phillips driver or even an allen wrench if those are the types of screws used. Save the screws so they can be replaced when the job is finished. 2.Undo the ends of the wire from inside the device using pliers or, if caps are used, unscrew them using fingers or pliers, depending on the tightness of the cap. Solder may be there so a de-soldering tool should be kept handy. 3.Use a multimeter that is set on resistance times one. If the cord is functional, the meter should read 0 ohms. If the entire length of the cord is bent and stretched out it, should continue to show no leakage. If the multimeter displays wildly fluctuating numbers, the cord is bad and needs to be replaced. When testing wires, press one probe to each exposed wire. It doesn't matter which probe touches which wire. The multimeter itself can be tested by touching the two probes together. 4.Always replace the old cord with a new one of an identical length so that the device will not receive too little or too much power. An excessive variation could damage the device. Also, in the case of a removable cord, one size does not fit all. Check the device carefully to know the size of the plug before replacing the cord. 5.If the cord is removable, a multimeter set to measure resistance is used to test both the male and female ends of the cord. One probe is touched to the male end of the wire and the other probe is inserted into the female end. Just as with the attached cords, these cords should be bent and extended. Zero ohms will be the reading in a good power cord.